INTERNATIONAL JOURNAL OF

HEAT EXCHANGERS

Bengt Sundén
Editor-in-Chief
Click for Subscription Specifications
ISSN 1524-5608  

Article Abstracts  

RECENT CONTENTS

VolumeYear
Volume I 2000Volume V2004Author / Title Index to Papers (Volume I through Volume V)
Volume II 2001Volume VI2005
Volume III 2002Volume VII2006
Volume IV 2003


VOLUME I NUMBER 1 (June 2000)

  • Enhanced Thermal-Hydraulic Performance Optimization of Chevron Plate Heat Exchangers
    A. Muley and R.M. Manglik

  • Dynamic Behaviour of Matrix Heat Exchangers
    Y. Xuan and W. Roetzel

  • Local Heat Transfer Coefficients in a Finned Tubular Heat Exchanger Using Liquid Crystal Thermography
    D.B. Murray, B. McMahon, and D. Hanley

  • Recent Progress on the Air-Side Performance of Fin-and-Tube Heat Exchangers
    C-C. Wang

  • R-22 Replacement Aspects in Compact Heat Exchangers for Air Conditioning
    G. Boccardi, G.P. Celata, M. Cumo, A. Gerosa, F. Marchesi-Donati, and A. Zorzin

  • Heat Transfer to a Supercritical Hydrocarbon Fuel with Endothermic Reaction
    W. Yu, D.M. France, and M.W. Wambsganss



  • VOLUME I NUMBER 2 (December 2000)

  • The Effect of Aspect Ratio on Turbulent Flow Heat Transfer and Pressure Drop in a Plate Heat Exchanger
    S.H. Lee, Y.I. Cho, C. Bai and D.J. Cho

  • An Experimental Investigation of Steam Condensation in Plate Heat Exchangers
    L. Wang, R. Christensen and B. Sundén

  • Dynamic simulation of plate-fin heat exchangers using a moving grid algorithm
    X. Luo and W. Roetzel

  • Experimental Design and Setup for Heat Exchanger Modeling
    K.K. Andersen, O.P. Palsson, H. Madsen and L.H. Knudson

  • Influence on Fin Spacing, Fin Thickness, and Inlet Velocity on the Performance of Plate Fin Heat Sinks Under Varying Bypass Conditions Using CFD
    H. Jonsson and B. Moshfegh


  • VOLUME II NUMBER 1 (June 2001)

  • Experimental Evaluation of R22 and R407C Pressure Drop During Horizontal Annular Flow Boiling
    C. Aprea, A. Greco and R. Mastrullo

  • Performance Evaluation of Different Heat Sinks
    G.A. Quadir, K.M. Siddiqui, L.W. Keat and C.Y. Meng

  • An Improved Three-Dimensional Numerical Model of Flow and Heat Transfer Over Louvered Fin Arrays
    S.M. El-Hawat, M.R. Heikal and S.S. Sazhin

  • Prediction of the Thermal Performance of Multistream Plate-fin Heat Exchangers
    X. Luo, K. Li and M. Li

  • Thermal Design of Spiral Heat Exchanger
    T. Bes

  • Modeling and Analysis of Post Dryout Cooling in Heat Exchanger Tubes
    R.K. Sahoo and A.K. Satapathy

  • Studies on Axial Dispersion of Concentration Profiles in Cascaded Stirred Tanks
    S.K. Das, A. Roy and F. Balzereit


  • VOLUME II NUMBER 2 (December 2001)

  • An Experimental Study of Spray Evaporation of Ammonia in a Square-Pitch, Low-Fin Tuble Bundle
    X. Zeng, M.-C. Chyu and Z.H. Hyub

  • Empirical Airside Correlations of Fin and Tube Heat Exchangers Under Dehumidifying Conditions
    C.C. Wang, W.S. Lee, W.J. Sheu and J.S. Liaw

  • A Transient Finite Element Analysis of Single, Double, and Triple Stack Cold Plates
    S.L. Beh, G.A. Quadir and K.N. Seetharamu

  • Theoretical and Experimental Investigations on Thermal Performance Analysis of Cross Flow Heat Exchangers
    D. Gangacahrayulu

  • An Experimental Study of a Water Filled Thermosuphon Heat Pipe Heat Exchanger
    C.-F. Than and M.O. Kalal


  • VOLUME III NUMBER 1 (June 2002)

  • A Computational Approach to Conjugate Heat Transfer between Two Fluids in Plate Heat Exchangers of Arbitrary Geometry
    M. Ciofalo and I. DiPiazza

  • Study of Single-Phase Heat Transfer and Pressure Drop in Plate Heat Exchangers with and without Anti-Fouling Coatings
    L. Cheng and G. Xia

  • EHD-Enhanced External Condensation of R-134a on Enhanced Tubes
    M. Molki, M.M. Ohadi and L.W. DaSilva

  • A Transient Analysis of Microchannel Heat Exchangers using the Finite Element Method
    G.A. Quadir, B.S. Lin and K.N. Seetharamu

  • Heat and Mass Transfer in Longitudinal Flow Helical Tube Heat Exchangers
    B.V. Dzyubenko and G.A. Dreitser

  • Effective Heat Transfer Enhancement in Tubular Heat Exchangers under Single-Phase Flow, Boiling, Condensation and Fouling Conditions
    G.A. Dreitser, A.S. Myakotchin and L.E. Lobanov


  • VOLUME III NUMBER 2 (December 2002)

  • Finite element analysis of wire-on-tube heat exchangers under forced convection conditions
    G.A. Quadir, G.M. Krishnan, and K.N. Seetharamu

  • Smooth and enhanced tube heat transfer and pressure drop
    N.T. Obot, L. Das, and T.J. Rabas

  • Compact heat exchangers for phase change
    V. Wadekar

  • Enhanced heat transfer in shell-side condensation
    A. Bontemps and M. Belghazi

  • Analysis of some heat exchanger concepts for use as gas turbine intercoolers
    A. Saidi, D. Eriksson, and B. Sunden


  • VOLUME IV NUMBER 1 (June 2003)

  • Conjugate heat transfer for a minimal unit model of counter flow type corrugated primary surface heat exchangers
    H. Iwai, H. Watanabe, K. Tatsumi, and K. Suzuki

  • Analysis of two- and multi-stream plate heat exchangers in optimization of heat exchanger networks
    L. Wang and B. Sunden

  • Heat exchanger design by entropy generation and present cost minimization
    E.B. Ratts

  • A new procedure for two-phase thermal analysis of multi-pass industrial plate-fin heat exchangers
    F. Ladeinde and K. Alabi

  • Local transient behavior of a compact heat exchanger core during brazing
    D.P. Sekulic, A.J. Salazar, F. Gao, J.S. Rosen and H.F. Hutchins


  • VOLUME IV NUMBER 2 (December 2003)

  • Compact heat exchanger for latent heat recovery of exhaust flue gas
    J. Mihara, T. Itoh, S. Horiki and M. Osakabe

  • Experimental validation of the homogeneous model for R407C in an air cooling evaporator
    C. Aprea

  • Convective heat transfer in dropwise condensation of multicomponent mixtures with inert gases
    F.L.A. Ganzevles and C.W.M. van der Geld

  • Heat transfer and pressure drop in spirally corrugated tubes
    O. Persson and U. Bolmstedt

  • The wetted area fraction of dropwise condensation with inert gases and drop drainage
    F.L.A. Ganzevles and C.W.M. van der Geld

  • Research and development on the high performance ceramic heat exchangers
    M. Kumada and K. Hanamura


  • VOLUME V NUMBER 1 (June 2004)

  • Flow visualization inside the wavy channels
    C.C. Wang, M.T. Hung, R.H. Yeh, Y.J. Chang and S.P. Liaw

  • Transient-based technique for the evaluation of the overall heat transfer coefficient in a concentric tube heat exchanger
    S.V. Mokamati and R.C. Prasad

  • Electrode design for HED enhancement of boiling and condensation in shell and tube heat exchangers
    R.K. Al-Dadah and T.G. Karayiannis

  • Modeling of condensation of steam in a vertical tube in the presence of a noncondensable gas
    M.M. Sorour, M.A. Teamah, S. Soliman and Y. Rihan

  • Optimal operation of heat exchanger networks under uncertainty
    K. Li and B. Niemeyer

  • Study on neural network model of frost growth
    Z. Liu and G. Tang

  • An experimental study of convective heat transfer for an inclined rectangular plate
    D.B. Murray, C. Ramierez and S. Holleran

  • Fouling in plate-and-frame heat exchangers and cleaning strategies
    S.M. Zubair and R.K. Shah

  • Numerical analysis of self-sustained flow oscillations in flat and wavy interrupted fin heat exchangers
    G. Croce and P. D'Agaro

  • Development of bubbly boiling in refrigeration heat exchangers
    T. Bohdal

  • Electrokinetic slip flow in microfluidic-based heat exchangers with rectangular microchannels
    J. Yang and D.Y. Kwok

  • Thermal performance evaluation of closed air circuit aircooled (CACA) heat exchangers for high rated electrical motors - A case study
    D. Gangacharyulu, R.K. Sharma, K.B. Dora and A. Kumar


  • VOLUME V NUMBER 2 (December 2004)

  • Heat transfer from an array of cylinders in oscillatory flow
    K. Muralidhar and K. Suzuki

  • Measurements and predictions of heat transfer at the tube-fin junction for louvered fin heat exchangers
    C.P. Ebeling and K.A. Thole

  • Optimization design of thermoacoustic pin-array stack
    Q. Tu, Q. Li, J.X. Li, Z.Y. Li, and F.Z. Guo

  • Enhancement of nucleate pool boiling heat transfer by reentrant cavity horizontal tubes
    K.G. Rajullu, R. Kumar, B. Mohanty, and H.K. Varma

  • Plate fin heat exchanger network retrofit procedure
    I. Bulatov

  • Non-dimensional entropy analysis of condenser and/or evaporator type heat exchangers
    A. Galovic

  • Heat exchangers of the gas-gas type based on finned heat pipes
    A. Gershuni, A. Nilshchik, Y. Pysmennyy, G. Polupan, F. Sanchez-Silva, and I. Carvajal-Mariscal

  • Study and visualization of droplet entrainment from a polymer compact heat exchanger
    L. Cheng, C.W.M. van der Geld, and A.S. Lexmond

  • Optimum design of crossflow plate-fin heat exchangers through genetic algorithm
    M. Mishra, P.K. Das, and S. Sarangi

  • Cumulative Author-Title Index to Volumes I-V

  • Contents for Volume VI forward


  • [ home ] [ contact ] [ subscribe ] [ call for papers ] [ editorial board ] [ editor-in-chief ]
    [ information for contributors ] [ library recommendation ] [ transfer of copyright form ]
    [ subscription policies ] [ advance contents notification ] [ sample copy request ]
    [ advertising information ] [ subscription agents ]